Kramer Electronics VS-6464DN - Manual (Page 16)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-6464DN 64x64 Digital Matrix Switcher
12
To install 1 Figure 4 the VS-6464DN as illustrated in the example in :
1. Connect up to 64 DVI video sources (for example 2
2. Connect up to 64 DVI video acceptors, (for example
, computer graphics
sources).
2 , a plasma display
and a DVI LCD display).
3. If required, connect a PC or remote controller to the RS-232 port (see
Section 6.1 ) and/or the Ethernet port (see Section 6.3 ).
4. Connect the power cord 3
5. If necessary, review and set the system configuration using the Menu
(see Section
.
8 ).
Note: Following HDCP regulations, if an input signal is HDCP encoded the
VS-6464DN will output a signal only if the output port to which it is
switched supports HDCP.
6.1 Port Numbering
On all cards apart from the DVI dual link cards, there are eight physical
ports and the numbering of ports is sequential from top to bottom and left to
right. Each DVI dual link card provides four physical ports which causes
the loss of four numbers in the numbering sequence. Figure 5 illustrates a
sample numbering showing only the top of each card and is explained in
Table 4 .
1 Switch off the power for each device before connecting it to your VS-6464DN
2 In this example only two inputs and two outputs are connected
3 We recommend that you use only the power cord that is supplied with the device (not shown in
Figure 4 )