Kramer Electronics VS-6464DN - Manual (Page 29)

Using the Configuration Menu
25
25
sets the time delay for an output which lapses between entering a switching
action and the execution of the action. This delay can be set for each output
independently. The delay is defined in units of 200ms and ranges from 0 to
15, providing delays of between 0 and 3 seconds (15 x 200ms = 3 seconds).
To set the execution delay for an output:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 9 (DELAY) on the numeric keypad (see Figure 2 ).
The output/delay times display is shown.
3. Using the numeric keys, enter the output (in this example, 03).
The following is displayed:
01 02 03 04 05 06 07 08
DLY__ =>out03
4. Using the numeric keys, enter the number of delay units.
5. Press TAKE.
The selected output delay is set.
The display reverts to the output/input display.
8.1.5 Setup Menu—4: store setup XX, Storing the Setup in a Preset
This option stores the current setup in a preset (1 to 59).
To store the current setup in a preset:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 4 (STO) on the numeric keypad (see Figure 2 ).
The following is displayed:
store => __
3. Using the numeric keys, enter the preset (1 to 59) in which to store the
current setup.
The following is displayed:
Wait …..
After a few seconds, if the preset is not empty, the following is
displayed:
SETUP NOT EMPTY
CONFIRM
The TAKE button flashes.
4. Press TAKE.
The setup is stored in the selected preset for subsequent recall.
The display reverts to the output/input display.