2 using the selector buttons, 3 confirming actions, Using the selector buttons – Kramer Electronics VS-6464DN User Manual
Page 22: Confirming actions, Ection 7.2

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Video Matrix Switcher
18
view any of the matrix combinations use the ◄ or the ► buttons on the
front panel to shift the sliding window to the right or left.
This sliding window functionality is enabled when:
•
The switcher is in between operations
•
Recalling a setup using the ◄ or ► buttons
When entering an output/input combination, the contents of the LCD display
automatically shift to indicate the current status of the selected output.
7.2 Using the Selector Buttons
For numbers between 1 and 9, the VS-6464DN can handle two digit
numbers as well as single digit numbers. When entering a single digit
number (for example 5), you can either press 0 followed by 5, or 5 followed
by ENT.
Pressing 00 (or 0, ENT) is only relevant for an input selection and is used to
disconnect the currently entered output number from the input.
For example, the following display indicates that inputs 8 and 12 are
disconnected from any output (note that in the second line representing
these inputs the display is blank):
06 07 08 09 10 11 12 13
12
08 10 14 13 06
The ESC button is used to cancel an operation without affecting the current
status. For example, if you enter an incorrect number by mistake, press the
ESC button to cancel the operation.
Note: At any stage, if no button is pressed within approximately 15
seconds, the automatic timeout causes the VS-6464DN to exit the operation
and revert to the output/input display.
7.3 Confirming Actions
You can choose to work in the At Once (default
In the At Once mode:
) or the Confirm mode.
•
The TAKE button does not light
•
Pressing an OUT-IN combination implements the switch without
further user confirmation
•
You save time as execution is immediate and actions require no user
confirmation
1 Waiting for its next operation while all previous operations are complete or cancelled
2 For all actions except storing/recalling