beautypg.com

1 config menu—input signal detection display, 2 config menu—output load detection display, Config menu—input signal detection display – Kramer Electronics VS-6464DN User Manual

Page 31: Config menu—output load detection display

background image

Using the Configuration Menu

27

27

Use the Config Menu as follows:

1. Press the MENU button to cycle through the menu items

1

2. Press the ENT button to enter a submenu.

.

3. After entering a submenu, you can select between several options.

Select an option by pressing one of the illuminated buttons in the

Selector Buttons area.

4. After selecting the desired option, a description of the desired change

is displayed and the TAKE button flashes.

5. Press the flashing TAKE button to confirm the change.

A description of the current state is displayed for about one second.

The unit automatically switches to the next item in the menu.

8.2.1 Config Menu—Input Signal Detection Display

This option displays a list of inputs and indicates on which of them signals

have been detected.
To display a list of inputs that have detected signals:

1. Press MENU twice.

The following message is displayed:

start configuration menu

MENU to view setup ENT to change them

2. Press MENU.

The following is displayed:

IN: 01 02 03 04 05 06 07 08 09 10 11

SIG: Y X Y Y Y Y X Y Y Y X

Y indicates that a signal is detected and X indicates that no signal is

detected on the relevant input.

3. Do one of the following:

Press BREAKAWAY to exit the Config Menu

Wait approximately 15 seconds for the operation to time out

Press MENU to move to the next Config Menu option

8.2.2 Config Menu—Output Load Detection Display

This option displays a list of outputs and indicates which have loads

attached to them.
To display a list of outputs and attached loads:

1. Press MENU twice.

The following message is displayed:

start configuration menu

MENU to view setup ENT to change them

1 The LCD display shows the current status of the selected menu item