beautypg.com

2 switching several inputs to several outputs, 3 turning an output off, Switching several inputs to several outputs – Kramer Electronics VS-6464DN User Manual

Page 24: Turning an output off

background image

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Operating Your Video Matrix Switcher

20

06 07 08 09 10 11 12 13

In__ => Out 12

The left-hand side of the display shows a section of the output/input

display automatically sliding the content to include output 12.

2. Using the numeric keypad, enter the required input (in this example,

14):

In the At Once mode, the switching takes place immediately and

the LCD display shows a segment of the input-output status that

includes the switched input and output (for example, 14-12)

In the Confirm mode, the LCD display shows the following:

In 14 => Out 12

Incomplete actions time out after approximately 15 seconds.

In the Confirm mode, press the flashing TAKE button to switch

the input to the output

7.4.2 Switching Several Inputs to Several Outputs

If you want to switch several inputs to several outputs simultaneously you

must be in the Confirm mode.
In the Confirm mode you can enter a batch of several actions and then

confirm the batch by pressing TAKE once (simultaneously switching

several output-input combinations).
To switch several inputs to several outputs in the Confirm mode:

1. Using the numeric keypad, enter an output-input combination.

The TAKE button flashes.

2. Enter additional output-input combinations.

The LCD display can show up to five pending actions (although the

batch is not limited to five actions)

1

09 => 06 05 => 07

:

3. After entering all output/input combinations, press the flashing TAKE

button to confirm the actions.

The inputs switch to the respective outputs as shown on the LCD

display and the TAKE LED is lit.

7.4.3 Turning an Output Off

Turning an output off means that there is no input switched to this output.

This is indicated on the display by the Input being blank underneath the

relevant Output.
To turn an output off:

1. Press MENU.

The Menu buttons light and are enabled.

1 In this example, input 9 is set to switch to output 6 and input 5 is set to switch to output 7