1 toggling between the at once and confirm modes, 2 confirming a switching action, 4 switching actions – Kramer Electronics VS-6464DN User Manual
Page 23: 1 switching one input to one output, Toggling between the at once and confirm modes, Confirming a switching action, Switching actions, Switching one input to one output, N 7.3.2

Operating Your Video Matrix Switcher
19
19
•
No protection is offered to correct an erroneous action
In the Confirm mode:
•
The TAKE button lights
•
You enter an action and then confirm it by pressing the TAKE button
•
Every action requires user confirmation, protecting against erroneous
actions
•
Execution is postponed until you confirm the action
7.3.1 Toggling between the At Once and Confirm Modes
To toggle between the At Once and Confirm modes:
Note: If the TAKE button is flashing you cannot toggle between the At
Once and Confirm modes. A flashing TAKE button indicates that an action
is currently pending confirmation.
1. Press TAKE to toggle between the At Once mode and the Confirm
mode.
The TAKE button lights and actions now require user confirmation.
2. Press the lit TAKE button to toggle from the Confirm mode back to the
At Once mode.
The TAKE button is no longer lit and actions no longer require user
confirmation.
7.3.2 Confirming a Switching Action
Actions only require confirmation when the device is in the Confirm mode.
To confirm a switching action:
1. Using the numeric keypad, enter an output-input combination.
The TAKE button flashes.
2. Press the flashing TAKE button to confirm the action.
The action is confirmed and the TAKE button lights.
7.4 Switching Actions
This section describes how to:
•
Switch one input to one output (see
Section 7.4.1
•
Switch several inputs to several outputs (see
Section 7.4.2
•
Turn off several outputs (see
Section 7.4.3
7.4.1 Switching one Input to one Output
To switch one input to one output:
1. Using the numeric keypad, enter the required output (in this example,
12).
The following is displayed:
1 Failure to press the TAKE button within a few seconds results in the action timing out automatically