5 locking the front panel buttons, 8 using the configuration menu, 1 using the setup menu – Kramer Electronics VS-6464DN User Manual
Page 26: Locking the front panel buttons, Using the configuration menu, Using the setup menu, On 7.5, On 8

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the Configuration Menu
22
7.5 Locking the Front Panel Buttons
You can lock
To lock the front panel buttons:
the VS-6464DN to prevent tampering with the unit or
prevent the settings from being changed accidentally via the front panel
buttons.
•
Press and hold LOCK until the button lights.
The front panel buttons are locked
To unlock the front panel buttons:
•
Press and hold LOCK until the button is no longer lit.
The front panel buttons are unlocked
8 Using the Configuration Menu
The configuration menus let you configure the VS-6464DN to best suit your
needs. There are two configuration menus:
•
Setup Menu—those that are accessed on a regular basis (for example,
storing setups and setting the delay), see
Section 8.1
•
Config Menu—those that are accessed only occasionally (for
example, setting the interface or communication protocol), see
Section 8.2
The following rules apply to the menu operation:
•
If no selection is made within approximately 15 seconds, the
operation times-out and the display reverts to the output/input display
•
At any point in the Menu, press ESC to move up one level or press
BREAKAWAY to exit the Menu altogether
•
At any point in the Menu, only buttons that are active light or flash
•
All of the procedures in this section assume that you are starting the
procedure from the standard, operational output/input display
8.1 Using the Setup Menu
The Setup Menu provides access to settings that are regularly changed and
comprises the following options:
•
1: inXX=>ALL, switching one input to all outputs (see
Section
•
3: outXX=OFF, turning off an output (see
Section 8.1.2
•
7: EDID, assignment to an output (see
Section 8.1.3
•
9: Delay setting for an output (see
Section 8.1.4
•
4: store setup XX, storing the setup in a preset (see
Section 8.1.5
•
6: recall setup XX, recalling a preset (see
Section 8.1.6
1 You can still operate the device remotely via RS-232 or Ethernet when the front panel is locked