1 installing the video generator, 2 setting the resolution of the generated video, Installing the video generator – Kramer Electronics VS-6464DN User Manual
Page 36: Setting the resolution of the generated video, N 10.2

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the Video Generator to Troubleshoot Video Problems
32
10 Using the Video Generator to Troubleshoot Video
Problems
The VS-6464DN includes a video generator which can be used to diagnose
video/audio issues in an operating environment.
The video generator must be configured in the setup before it can be used.
When installing the video generator, the number of configured inputs and
outputs must be increased by one. For example:
•
If your VS-6464DN has eight inputs and twelve outputs, you must
configure the VS-6464DN as 9 x 13
•
If your VS-6464DN has 64 inputs and 64 outputs, you must
configure the
VS-6464DN as 65 x 65
10.1 Installing the Video Generator
To install the video generator in the configuration:
1. Press ESC, ENT and LOCK together.
The following is displayed:
Configuration Device
2. Press ENT.
The following is displayed:
Test Board: 0 MaxInput:64 MaxOutput:64
where 0 indicates that the test module is not installed.
3. Using the numeric keys, press 1 to indicate that the test module is
installed.
The TAKE button flashes.
4. Press TAKE.
5. Increase the number of configured inputs and outputs by one (see
Section 9
).
The test module is now installed and may be used.
10.2 Setting the Resolution of the Generated Video
The video generator produces a range of both PC and HD resolutions which
are selected by a combination of DIP-switches and an on-board jumper
(labeled B3). Install the jumper to select HD resolutions or remove the
jumper to select PC resolutions.
The Resolution DIP-switch is used to set the resolution of the generated
Table 7
.