beautypg.com

4 turning off several outputs, 5 recalling the default setup, Turning off several outputs – Kramer Electronics VS-6464DN User Manual

Page 25: Recalling the default setup, On 7.4.5

background image

Operating Your Video Matrix Switcher

21

21

2. Press OFF (3) on the numeric keypad (see

Figure 2

).

The following message is displayed:

out__ => OFF

3. Use the numeric keypad to turn the required output off.

The output is turned off.

To turn an output off in the Confirm mode:

Repeat the steps above and then press the flashing TAKE button to

confirm the action

Alternatively, you can perform a switching operation (see

Section 7.4.1

)

and set the input to 00.

7.4.4 Turning Off Several Outputs

To turn off several outputs in the Confirm mode, repeat the switching

actions described in

Section 7.4.2

but set the inputs to 00.

7.4.5 Recalling the Default Setup

You can store a commonly used setup as the default setup (see

Section

8.2.6

) which can be recalled at any time.

Note: This is not the setup that is loaded when the unit is turned on. When

the unit is turned on, the setup that was last used before the unit was turned

off is loaded.
To recall the default setup:

1. Press DEFAULT SETUP.

The DEFAULT SETUP button flashes and the following message is

displayed:

recall DEFAULT setup

press FLASHING button to confirm

2. Press DEFAULT SETUP.

The following message is displayed:

all Setups and Connections change

press TAKE to confirm

The TAKE button flashes.

3. Press TAKE.

The default setup is recalled and the display reverts to the output-input

display.