2 using the config menu, Setup menu—6: recall setup xx, recalling a preset, Using the config menu – Kramer Electronics VS-6464DN User Manual
Page 30: N 8.2

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the Configuration Menu
26
8.1.6 Setup Menu—6: recall setup XX, Recalling a Preset
This option recalls a stored configuration from a preset (1 to 59).
To recall a stored configuration:
1. Press MENU.
The Setup Menu options are displayed.
2. Press 6 (RCL) on the numeric keypad (see
).
The following is displayed:
recall <= __
3. Using the numeric keys, enter the preset (in this example, 02) to recall.
The following is displayed:
Wait …..
After a few seconds, the following is displayed on the right hand side:
CONFIRM
RECALL <= 02
The TAKE button flashes.
4. Press TAKE.
The preset is recalled.
The display reverts to the output/input display.
8.2 Using the Config Menu
The Config Menu provides access to configuration settings that are not
regularly changed and comprises the following options:
•
Input signal detection (
Section 8.2.1
•
Output load detection (
Section 8.2.2
•
Interface configuration (
Section 8.2.3
•
Interface Reply configuration (
Section 8.2.4
•
Protocol configuration (
Section 8.2.5
•
Storing the default setup (
Section 8.2.6
•
Resetting the VS-6464DN (
Section 8.2.7
•
Firmware revision display (
Section 8.2.8
To enter the Config Menu press MENU twice. The MENU button lights and
the following message is displayed:
•
Start configuration menu
•
MENU to view setups ENT to change them
When browsing through the configuration menu, enabled buttons light or
flash.