beautypg.com

11 i/o card hardware installation instructions, I/o card hardware installation instructions, Figure 11: inserting the card into a slot – Kramer Electronics VS-6464DN User Manual

Page 39

background image

I/O Card Hardware Installation Instructions

35

35

To test the input and output signal path to the projector:

1. Configure Input 33 to Output 33 (see

Section 7.4

).

2. Connect Output 33 to Input 1.

3. Configure Input 1 to Output 1.

4. Connect Output 1 to the projector.

5. Set the generated video resolution (see

Section 10.2

).

6. Set the pattern for the generated video (see

Section 10.3

).

7. Verify that the projector output is as expected.

11 I/O Card Hardware Installation Instructions

The VS-6464DN I/O cards mount in one of the 16 slots on the rear of the

VS-6464DN chassis. Slots are numbered from left to right and must be

filled consecutively from left to right, without leaving empty slots.
WARNING: An input card must only be mounted in a slot designated for

input cards (slots IN 1 to 32 and IN 33 to 64) and an output card must only

be mounted in a slot designated for output cards (slots OUT 1 to 32 and

OUT 33 to 64).

Figure 11: Inserting the Card into a Slot