Festo Кабели и принадлежности - Manual (Page 66)

PLEASE NOTE
In order to correct the byte swap, it will suffice if you
swap the assignment of the two bytes.
Individual I/O assignment at bit level is only necess-
ary in a few cases.
The following dialogue window shows the entries
necessary for swapping/correcting the assignment of
the high and low bytes (example: byte swap for stand-
ard mode).
©
P33 = Inbyte_0 (Byte swap)
Fig. 4/14: Byte swap correction – example for standard mode
©
©
4. Commissioning
4-32 SPC200-COM-IBS 0503a