Festo Кабели и принадлежности - Manual (Page 64)

4.4.3 Entering process data via the CMD software
The CMD software offers as from version 4.x the possi-
bility of assigning any output of the PLC/IPC to each
input or output of the field bus module of the SPC200,
within the configured address range. In order to do this,
proceed as follows:
•
Add the SPC200 to your bus structure (necessary
steps see section 4.3.1, “Bus configuration with CMD
software”).
•
Use the right-hand mouse button to open the dia-
logue window of the inserted SPC200.
•
Select the option “Process data”.
Fig. 4/12: Option for entering the process data
4. Commissioning
4-30 SPC200-COM-IBS 0503a