Festo Кабели и принадлежности - Manual (Page 51)

The following dialogue window will then appear:
Fig. 4/6: Dialogue window “Insert Device"
Enter the following in the dialogue window:
•
ID Code
Enter Ident-code 3 for the SPC200.
•
Process Data Channel
Enter here the appropriate number of bits, depending
on the operating mode of the SPC200 and on the I/O
configuration set with WinPISA (see Chapters 4.2.2
and 4.1.3).
•
Device Type
Enter here the default entry “Remote bus device.”
•
Save these entries by pressing the OK button.
4. Commissioning
SPC200-COM-IBS 0503a 4-17