NOVUS V1.5x A - Manual (Page 97)

NOVUS AUTOMATION www.fieldlogger.net 97/103
4. Replace the plug and powering cord of the equipment, then turn FieldLogger ON again. The status and USB LEDs
should flash together, indicating that the boot loader is running.
5. The status led should still be flashing in the same pattern. The USB led should flash quickly while the flogger.flb file
copy is being performed. Once the copy has been done, the USB led should stay lit, indicating that the USB flash
drive can be removed.
6. If during the copy (writing) of the firmware of FieldLogger there is some kind of error, this will be indicated by the
status led that is to stop flashing periodically and repeatedly showing a pattern of blinking as per the occurred error.
Blinks Meaning
1 An error occurred in reading flogger.flb file.
2 Error in initializing the FieldLogger USB host (when inserting the USB flash drive)
3 Error in erasing the FieldLogger program memory.
4 Error in writing the FieldLogger program memory.
5
The written firmware is bigger than the program memory available in the FieldLogger. The
writing was partial.
6 Error in closing flogger.flb file.
7 Invalid flogger.flb file.