NOVUS V1.5x A User Manual
Page 100
NOVUS AUTOMATION
www.fieldlogger.net
100/103
• Unscrew the four screws located under the enclosure. Remove the back cover, taking care not to remove the circuit
board.
• After removing the back cover, remove the battery. Avoid touching the circuit board!
• Insert the new battery and put back the back cover and its four screws.
See also other documents in the category NOVUS Sensors:
- N480D (6 pages)
- N1500FT Indicator (9 pages)
- TxBlock-USB Transmitter (4 pages)
- Controller N2000 (11 pages)
- Controller N2000 (9 pages)
- Controller N120 (14 pages)
- TxIsoLoop-1/TxIsoLoop-2 (2 pages)
- DigiRail-VA (19 pages)
- TagTemp-USB (5 pages)
- Controller N960 (6 pages)
- Controller N3000 (11 pages)
- Controller N3000 (9 pages)
- N1540 Process Indicator (5 pages)
- Controller N480D (6 pages)
- LogBox-DA (7 pages)
- N1040i Indicator (6 pages)
- N1040i Indicator (3 pages)
- N1020 (2 pages)
- N1020 (8 pages)
- DigiGate Profibus (11 pages)
- DigiGate Profibus (10 pages)
- N120/N125 CONTROLLER (13 pages)
- AirGate-Modbus (22 pages)
- RHT-Air (8 pages)
- Controller N1200 (13 pages)
- TxMiniBlock (2 pages)
- AirGate-GPRS (29 pages)
- DC80T (13 pages)
- RHT - WM (2 pages)
- Controller N1100 (11 pages)
- Controller N1100 (8 pages)
- superview (38 pages)
- RHT-WM-485-LCD (6 pages)
- TxIsoRail 4-20 mA (3 pages)
- N1540 Indicator (2 pages)
- TXRAIL0 - 10VDC (2 pages)
- TagTemp (7 pages)
- N323RHT (2 pages)
- RECIPE EDITOR (4 pages)
- TxIso Pack- HART (2 pages)
- n1500lc (14 pages)
- N2020 Controller (7 pages)
- N322T (2 pages)
- N321R (2 pages)