HID EDGE Solo v110 User Guide - Manual (Page 31)

Edge Solo User’s Guide 27
5
. . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Setting Up Cards
You can set up cards for use, even if you are not ready to assign them to a person yet.
However, for anyone to actually access the door with a card, you need to assign a card
and schedule to a person.
Note: Before you add a card, you must set up the format for your type of cards. For
more information, see
“Setting Up Card Formats” on page 27.
The following sections describe how to set up cards:
• “Setting Up Card Formats” on page 27
• “Adding Cards” on page 29
• “Reassigning a Card to a Different Person” on page 31
• “Viewing a List of All Cards” on page 32
• “Deleting Cards” on page 32
• “Downloading Card Information for Use in a Spreadsheet” on page 32
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S e t t i n g U p C a r d F o r m a t s
Before you add a card, you must set up the format for your type of card. When you set
up the format, you assign the format a name, select the correct format template, and
enter the code your installer gave you for each type of card.
Each type of card may use a different format to store information on the card. The
format your cards use is listed on the box of cards. The Edge Solo accepts the
following formats:
• Corporate 1000
• H10301 Standard 26-bit
• H10304 HID Managed 37-bit
• H10302 Open 37-bit
Each type of card has a company ID code or facility code listed on the box. Be sure you
have this code.