HID DTC4500e User Guide - Manual (Page 83)

DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
April 2014 Page 83
Error Message Cause Solution
# 82 Mag Jam A card is jammed magnetic
station
Clear any cards in the magnetic
station using the buttons to move
the card out.
Press the
Pause button to
continue.
# 91
Ribbon Out The print ribbon has run out. Install a new ribbon.
Press the
Pause button to
continue or the ON/OFF button to
cancel.
# 93
Wrong Ribbon The print ribbon installed in the
printer does not match the
ribbon type selected in the
printer driver.
Change either the installed print
ribbon or the ribbon type selected
in the printer driver.
Press the
Pause button to
continue or the ON/OFF button to
cancel.
# 97
Ribbon Search Error The ribbon is not able to find the
next panel correctly.
Check for jams/breaks.
Recalibrate the ribbon sensor.
If broken, repair by taping the
ribbon back on to the take- up
core.
Replace the ribbon.
Press the
Pause button to
continue or the ON/OFF button to
cancel.
# 99
Ribbon Error The print ribbon has either
broken or jammed.
If jammed, clear the jam.
If broken, repair by taping the
ribbon back on to the take- up
core.
Press the
Pause button to
continue or the ON/OFF button to
cancel.
# 100
Ribbon RFID Error There is no ribbon or the ribbon
tag information is corrupted or
incorrect.
Verify the printer driver settings
for correct Ribbon.
Try a new ribbon and continue.
Press the ON/OFF button to
cancel.