HID DTC4500e User Guide - Manual (Page 41)

DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
April 2014 Page 41
Setting Description
Resin Heat Adjust Use this adjustment for Black premium resin text and barcodes if
they appear faded, too light or too dark.
Maximum Adjustment Range is +/- 100.
Note: This control can be helpful for fine-tuning the transfer of
resin text and bar codes.
Sleep Time The Sleep Time setting adjusts the number of minutes of inactivity
before the Printer enters a low power sleep state.
OLED Contrast
(Display Contrast) Use this option to increase or decrease the contrast of the printer
OLED (if applicable).
Ribbon Calibrate Blue This setting is a calibration driven value and should not be
adjusted.
Note: This is factory set and should not be changed unless
directed by a technician.
Cleaning Rate Use this option to adjust the number of cards printed before the
Printer displays a message indicating cleaning is needed.
The default value is 3000 cards.
Mag HI-Co Voltage Offset This setting is a calibration driven value and should not be
adjusted.
Note: This is factory set and should not be changed unless
directed by a technician.
Mag Lo-Co Voltage Offset This setting is a calibration driven value and should not be
adjusted.
Note: This is factory set and should not be changed unless
directed by a technician..
Ribbon Green LED Level This setting is a calibration driven value and should not be
adjusted.
Note: This is factory set and should not be changed unless
directed by a technician.
Ribbon Blue LED Level This setting is a calibration driven value and should not be
adjusted.
Note: This is factory set and should not be changed unless
directed by a technician.