Allied Telesis AT-S10 TurboStack - Manual (Page 7)

vii
Preface
This guide describes the procedures to manage the Turbo Stack™ series of
management hubs using the software, AT-S10, and its management
agent, Omega.
The software is pre-installed in Turbo Stack management hubs.
Audience
This guide is written for you, the technical person responsible for
managing
Turbo Stack hubs. You must be familiar with Ethernet networks
and the devices used in these networks.
Before using this guide, you must have at least one management
Turbo Stack hub installed and operational in the network.
How this Guide is Organized
This guide consists of the following chapters and appendices:
Chapter 1, “Overview,” describes the features of the pre-installed AT-S10
software and Omega, the management agent.
Chapter 2, “Getting Started,” describes the initial setup steps for you to
begin managing your
Turbo Stack hub, and also introduces you to Omega’s
user interface.
Chapter 3, “Management Menus,” describes the menus you use to
configure and manage
Turbo Stack hubs.
Chapter 4, “Fault Tolerance,” describes the process by which modules in
the chassis automatically adapt to module failures and preserve
configuration data.