Allied Telesis AT-S10 TurboStack - Manual (Page 50)

Management Menus
40
“Trap” Community String. The default value is public . To change it,
enter J to display the screen as shown:
Then enter up to ten characters for the SNMP Trap community string.
Download Password. The default password, ATS10 (in uppercase),
displays as a series of asterisks for protection. If you want to change it,
enter K to display the following screen:
Enter the password you want the download process to use in sending
software to other TurboStack hubs. If you change the password, make sure
you configure the same download password for all TurboStack hubs so
they can receive downloaded software. That is, the hub downloading the
software and the hub receiving the software must use the same password.
See the section “Download Password” on page 40 and “TFTP” on page 58,
Chapter 5 for more information on how the download password is used.
Location String. This parameter is optional. Enter L to display the
following screen:
This string is displayed by SNMP management stations.
Sunnyvale
The current ‘ Trap ’ Community String is:
public
Please enter a new string, or Return to retain the existing one:
->
Sunnyvale
The current Download Password is:
******
Please enter a new string, or Return to retain the existing one:
->
Sunnyvale
‘Location’ is a string that identifies the physical location of
this device, e.g. “Second floor computer room” or “Joe’s office”.
The current Location string is:
Null (not currently configured)
Please enter a new string, or Return to retain the existing one:
->