Allied Telesis AT-S10 TurboStack - Manual (Page 67)

AT-S10 Management Software User’s Guide
57
To update a specific hub:
1. Select Send updated software to another hub from the
Administration menu.
The following screen appears:
2. Enter either the hub’s IP address, MAC address, or name.
3. The activity monitor appears, displaying messages about the download
process.
To update all hubs:
Perform this procedure during those times when the network is not busy.
Select Update software in all hubs from the
Administration menu.
The hub sends a broadcast message to all TurboStack hubs,
informing them about the download, then turns on the activity
monitor. All hubs running an older version of the software respond
by requesting the updated software, and you see the messages on
the monitor as each hub requests and then receives the updated
software; for example:
The numbers 00000 and 99999 are the beginning and ending
addresses, respectively, of the portion of memory currently being
downloaded.
Sunnyvale
Please specify the Hub to be downloaded:
The Hub to be downloaded may be identified by name (‘hub name’), by
IP address (128.2.3.4), or by Ethernet address (0000F4 123456).
->
Activity Monitor
(hit Return to resume the previous menu)
Download request received from Third Floor Hub
Sending...: 00000 - 99999
Load completed