Allied Telesis AT-S63 - Manual (Page 744)

Chapter 31: 802.1x Port-based Network Access Control
744 Section VIII: Port Security
Configuring Authenticator Port Parameters
Note
A port must already be set to the authenticator role before you can
configure its settings. For instructions on how to change the role of a
port, refer to “Setting Port Roles” on page 741.
To configure the parameters of an authenticator port, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 79 on page 281.
2. From the Security and Services menu, type 2 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 250 on
page 741.
3. From the Port Access Control menu, type 4 to select Configure
Authenticator.
The Configure Authenticator menu is shown in Figure 252.
Figure 252. Configure Authenticator Menu
4. From the Configure Authenticator menu, type 1 to select Configure
Authenticator Port Access Parameters.
The following prompt is displayed:
Enter port list ->
5. Enter the authenticator port number whose parameters you want to
change. You can configure more than one port at a time.
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Authenticator
1 - Configure Authenticator Port Access Parameters
2 - Display Authenticator Port Access Parameters
R - Return to Previous Menu
Enter your selection?