Allied Telesis AT-S63 - Manual (Page 253)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 253
Working with the Event Logs
This section contains the following procedures:
ˆ “Enabling or Disabling the Event Logs,” next
ˆ “Displaying an Event Log” on page 254
ˆ “Modifying the Event Log Full Action” on page 260
ˆ “Clearing an Event Log” on page 261
ˆ “Saving an Event Log to a File” on page 261
Enabling or
Disabling the
Event Logs
This procedure explains how to enable or disable the event logs on the
switch. If you disable the logs, the AT-S63 management software does not
store events in its logs and does not send events to any syslog servers.
The default setting for the event logs is enabled.
Note
Allied Telesyn recommends setting the switch’s date and time if you
enable the event logs. Otherwise, event messages will not have the
correct time and date. For instructions, refer to “Setting the System
Time” on page 66.
To enable or disable the event logs, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log. The
Event Log menu is shown in Figure 69.
Figure 69. Event Log Menu
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Event Log
1 - Event Logging .......... Enabled
2 - Display Output ......... Temporary (Memory)
3 - Display Order .......... Chronological
4 - Display Mode ........... Normal
5 - Display Severity ....... E, W, I
6 - Display Module ......... All
C - Clear Log
L - Configure Log Outputs
S - Save Log to File
V - View Log
R - Return to Previous Menu
Enter your selection?