Allied Telesis AT-S63 - Manual (Page 123)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 123
Configuring Port Parameters
To configure the basic parameter settings for a port, such as speed and
duplex mode, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 24 on page 120.
2. From the Port Configuration menu, type 1 to select Port Configuration.
The following prompt is displayed:
Enter port-list ->
3. Enter the number of the port to be configured. You can configure more
than one port at a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or both (for
example 1,5,14-22).
Note
For instructions on how to configure a redundant twisted pair port or
a port on an SFP or GBIC module, refer to “Redundant Twisted Pair
Ports” on page 55.
The Port Configuration menu is shown in Figure 26.
Figure 26. Port Configuration (Port) Menu
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Port Configuration
Configuring Port 11
0 - Description ........................ Port_11
1 - Status ............................. Enabled
2 - HOL Blocking Prevention Threshold .. 682 cells
3 - Flow Control
4 - Filtering
5 - Rate Limiting
6 - Negotiation ........................ Auto
X - Reset Port
F - Force Renegotiation
D - Set Port Configuration to Defaults
R - Return to Previous Menu
Enter your selection?