Allied Telesis AT-S63 - Manual (Page 632)

Chapter 25: GARP VLAN Registration Protocol
632 Section VI: Virtual LANs
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This
protects against unauthorized access to restricted areas of your
network. For further information, refer to “GVRP and Network
Security” on page 625.
To enable or disable GVRP on a port, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 199 on page 600.
2. From the VLAN Configuration menu, type 6 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 211 on page 630.
3. From the GARP-GVRP menu, type P to select GVRP Port
Parameters.
The GVRP Port Parameters menu is shown in Figure 212.
Figure 212. GVRP Port Parameters Menu
4. From the GVRP Port Parameters menu, type 1 to select Configure
GVRP Port Settings.
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?