Allied Telesis AT-S63 - Manual (Page 53)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 53
Note
A switch can support one manager session and eight operator
sessions simultaneously.
The local management session starts and the command line interface
(CLI) prompt is displayed, as shown in Figure 2 on page 47. For
information about the command line interface, refer to the AT-S63
Management Software Command Line Interface User’s Guide.
If the switch has been configured with a name, the name is displayed
below the switch’s model name.
3. To use the menus interface, type menu and press Return.
The Main Menu is shown in Figure 3 on page 48.
4. To select a menu item, type the corresponding letter or number.
5. To return to a previous menu, press the Esc key or type the letter R.
Quitting a
Remote
Management
Session
To end a remote management session, return to the Main Menu and type
Q for Quit.
Note
Failure to properly exit from a management session may block future
management sessions until the console timer times out.
You should always exit from a management session when you are finished
managing a switch. This can prevent an unauthorized individual from
making changes to a switch’s configuration if you leave your management
station unattended. For information about how to use the console timer to
automatically disconnect a management session, refer to “Configuring the
Console Timer” on page 74.