Allied Telesis AT-S63 - Manual (Page 270)

Chapter 12: Event Logs and Syslog Servers
270 Section II: Advanced Operations
15. Enter a list of modules separated by a comma—for example, “system,
stp, ptrunk.”
16. Type C to create the log output.
The switch adds the new syslog server definition to the Configure Log
Outputs menu and begins to send events to the sever, if you enabled
the definition when you created it. An example of the menu with a new
syslog server definition is shown in Figure 75.
Figure 75. Configure Log Outputs Menu with a Syslog Output Definition
17. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
Modifying a Log
Output
To modify an log output definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 69 on page 253.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 73 on page 265.
4. From the Configure Log Outputs menu, type 2 to select Modify Log
Output.
The following prompt is displayed:
Enter output ID to modify [0 to 20] ->
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Log Outputs
OutputID Type Status Details
------------------------------------------------------
0
Permanent Enabled Wrap on Full
1 Temporary Enabled Wrap on Full
2 Syslog Enabled 149.44.44.44
1 - Create Log Output
2 - Modify Log Output
3 - Delete Log Output
4 - View Log Output Details
R - Return to Previous Menu
Enter your selection?