Allied Telesis AT-S63 - Manual (Page 212)

Chapter 10: File System
212 Section II: Advanced Operations
Displaying System Files
Use this procedure to display a list of the system files currently stored
either in the flash memory of the switch or on a compact flash card. For
information about shortcuts for specifying file names, see “File Naming
Conventions” on page 197.
Listing All Files To display a list of the system files stored in flash memory as well as on a
compact flash card (if the switch supports this and a compact flash card is
inserted in the slot), perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 9 to select System
Utilities.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 53 on page 200.
4. From the File Operations Menu, type 8 to select List Files.
The following prompt is displayed:
Enter file name pattern to list:
5. Enter a boot configuration file name or pattern using the wildcard “*”.
Below are examples of how to use the wildcard to display different
files.
To display a list of all the files stored both in flash memory and on a
compact flash card in the same switch, enter:
*.*
To display a list of the certificate files, enter:
*.cer
To display a list of the boot configuration files, enter:
*.cfg
To display a list of the key files, enter:
*.key
To display a list of the files that begin with the letter t, enter:
t*.*