Allied Telesis AT-S63 - Manual (Page 395)

AT-S63 Management Software Menus Interface User’s Guide
Section III: IGMP Snooping, MLD Snooping, and RRP Snooping 395
Configuring MLD Snooping
To configure MLD snooping on the switch, perform the following
procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
The Advanced Configuration menu is shown in Figure 129 on page
384.
2. From the Advanced Configuration menu, type 3 to select MLD
Snooping Configuration.
The MLD Snooping Configuration menu is shown in Figure 133.
Figure 133. MLD Snooping Configuration Menu
3. Adjust the following parameters as necessary:
1 - MLD Snooping Status
Enables or disables MLD snooping on the switch. The default setting is
disabled.
2 - Host Topology
Defines whether there is only one host node per switch port or multiple
host nodes per port. The possible settings are:
Single-Host/Port (Edge)
The Single-Host/Port setting is appropriate when there is only one host
node connected to each port on the switch. This setting causes the
switch to immediately stop sending multicast packets out a switch port
when a host node signals its desire to leave a multicast group by
sending a leave request or when the host node stops sending reports.
The switch responds by immediately ceasing the transmission of
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
MLD Snooping Configuration
1 - MLD Snooping Status ............. Disabled
2 - Host Topology ................... Single-Host/Port (Edge)
3 - Host/Router Timeout Interval .... 260 seconds
4 - Maximum MLD Multicast Groups .... 64
5 - Router Port(s) .................. Auto Detect
6 - View MLD Multicast Hosts List
7 - View MLD Multicast Routers List
R - Return to Previous Menu
Enter your selection?