Removing a vlan from an msti id – Allied Telesis AT-S63 User Manual
Page 570
Chapter 23: Multiple Spanning Tree Protocol
570
Section V: Spanning Tree Protocols
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 190 on page
569.
5. From the VLAN-MSTI Association menu, type 1 to select Add VLANs
to MSTI.
The following prompt is displayed:
Enter the MSTI ID
6. Enter the MSTI ID to which you want to associate a VLAN.
A prompt similar to the following is displayed:
Enter the list of VLANs:
7. Enter the VLAN ID of the virtual LAN you want to associate with the
MSTI ID. You can enter more than one VLAN at a time (for example,
2,4,7). To view VIDs, refer to “Displaying VLANs” on page 611.
The MSTI ID retains any VLANs already associated with it when new
VLANs are added.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Removing a
VLAN from an
MSTI ID
To remove a VLAN from an MSTP ID, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 525.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 187 on page 558.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 189 on page 563
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 190 on page
569.
5. From the VLAN-MSTI Association menu, type 2 to select Delete
VLANs from MSTI.