Allied Telesis AT-S63 - Manual (Page 474)

Chapter 21: SNMPv3
474 Section IV: SNMPv3
The Configure SNMPv3 Target Address Table menu is shown in
Figure 151 on page 470.
3. From the Configure SNMPv3 Target Address Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is shown in Figure
152.
Figure 152. Modify SNMPv3 Target Address Table Menu
4. To change the Target IP Address, type 1 to select Set Target IP
Address.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter IP Address:
6. Enter the IP address of the host.
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager11:20:02 02-Mar-2005
Modify SNMPv3 Target Address Table
Target Addr Name ... host451 Timeout ..... 1500
Target Parameters .. SNMPmanagerPC Retries ..... 3
IP Address ......... 198.35.11.1 UDP Port# ... 162
Storage Type ....... NonVolatile Row Status .. Active
Tag List ........... hwengTrap hwengInform swengTrap swengInform
1 - Set Target IP Address
2 - Set Target Address UDP Port
3 - Set Target Address Timeout
4 - Set Target Address Retries
5 - Set Target Address TagList
6 - Set Target Parameters
7 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?