Allied Telesis AT-S63 - Manual (Page 288)

Chapter 13: Classifiers
288 Section II: Advanced Operations
Deleting All Classifiers
This procedure deletes all classifiers from the switch. To delete individual
classifiers, refer to “Deleting a Classifier” on page 287.
Note
You cannot delete all classifiers if any of them belong to an ACL or
QoS policy.You must first remove all classifiers from their ACL and
policy assignments before performing this procedure.
To delete all classifiers from the switch, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 79 on page 281.
2. From the Security and Services menu, type 1 to select Classifier
Configuration.
The Classifier Configuration menu is shown in Figure 80 on page 282.
3. From the Classifier Configuration menu, type P to select Purge
Classifiers.
Caution
No confirmation prompt is displayed. All classifiers are immediately
deleted from the switch.
4. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.