Allied Telesis AT-S63 - Manual (Page 86)

Chapter 6: Static Port Trunks
86 Section I: Basic Operations
4. To create a new static trunk, click Add.
The Add New Trunk page is shown in Figure 23.
Figure 23. Add New Trunk Page
5. Click the Trunk Name field and enter a name for the static trunk. The
name can be up to 16 alphanumeric characters. No spaces or special
characters, such as asterisks and exclamation points, are allowed.
Each trunk must have a unique name.
6. From the Trunk Method pull-down menu, select a load distribution
method for the trunk. The possible settings are:
SA - Source MAC address (Layer 2)
DA - Destination MAC address (Layer 2)
SA/DA - Source MAC address /destination MAC address (Layer 2)
SI - Source IP address (Layer 3)
DI - Destination IP address (Layer 3)
SI/DI - Source IP address /destination IP address (Layer 3)
7. In the switch image, click the ports to be in the port trunk. A selected
port changes to white. An unselected port is black. A static port trunk
can contain up to eight ports.