Allied Telesis AT-S63 - Manual (Page 216)

Chapter 17: SNMPv3
216 Section III: SNMPv3
Note
The “defaultViewAll” value is the default entry for the SNMPv1 and
SNMPv2c configuration. You cannot use the default value for an
SNMPv3 View Table entry.
6. In the Subtree OID field, enter a subtree that this view will or will not be
permitted to display.
You can enter either a numeric value in hex format or the equivalent
text name. For example, the OID hex format for TCP/IP is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp
7. In the Subtree Mask field, enter a subtree mask in hexadecimal format.
This is an optional parameter that is used to further refine the value of
the Subtree OID parameter.
The Subtree OID parameter defines a MIB View and the Subtree Mask
parameter further restricts a user’s view to a specific the column and
row of the MIB View. The value of the Subnet Mask parameter is
dependent on the subtree you select. For example, if you configure the
View Subtree parameter as MIB ifEntry.0.3, it has the following value:
1.3.6.1.2.1.2.2.1.0.3
To restrict the user’s view to the third row (all columns) of the MIB
ifEntry.0.3, enter the following value for the Subtree Mask parameter
ff:bf
8. In the View Type field, enter one of the following view types:
Included
Enter this value to permit the user to see the subtree specified above.
Excluded
Enter this value to not permit the user to see the subtree specified
above.
9. In the Storage Type field, enter a storage type for this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the View Table. After making changes to a View Table entry with a
Volatile storage type, the Save Config option is not displayed on the
Configuration menu.