Allied Telesis AT-S63 - Manual (Page 42)

Chapter 2: Port Parameters
42 Section I: Basic Operations
Configuring Port Parameters
To configure the parameter settings of a port on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 6.
Figure 6. Port Settings Tab (Configuration)
The Port Settings tab displays an image of the front of the switch.
Ports with a valid link to an end node are green.
3. In the switch image, click a port to configure. The selected port turns
white. You can configure more than one port at a time, though they
must all be the same type (i.e., all twisted pair ports or all fiber optic
ports). To deselect a port, click it again.
4. Click Modify. To configure all the ports, click Modify All.