Allied Telesis AT-S63 - Manual (Page 400)

Chapter 27: Management Access Control List
400 Section VII: Management Security
Creating an ACE
To add a new ACE to the management ACL, perform the following
procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Mgmt. Security option.
3. Select the Mgmt. ACL tab.
The tab is shown in Figure 164 on page 398.
4. To add a new ACE, click Add.
The Add New MACL page is shown in Figure 165.
Figure 165. Add New MACL Page
5. Configure the following parameters in the Add New MACL page:
MACL ID
Specifies an identification number for the access control entry. Every
ACE must have a unique number. The range is 1 to 256.
Mgmt. ACL Entry IP Address
Specifies the IP address of a management workstation to be allowed
management access to the switch (for example, 149.11.11.11).
Alternatively, you can specify a subnet. You must enter an IP address.
If you enter an IP address of a specific management node, that node
will be permitted remote management access to the switch. If you
enter a subnet, any management node in the subnet will be permitted
remote management access to the switch.