Allied Telesis AT-S63 - Manual (Page 380)

Chapter 25: Secure Shell (SSH)
380 Section VII: Management Security
Configuring SSH
To configure SSH, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Mgmt. Protocols option.
3. Select the Secure Shell tab.
The Secure Shell tab is shown in Figure 156.
Figure 156. Secure Shell Tab (Configuration)
4. Configure the following parameters as necessary:
Status
Enables and disables the SSH server. The default is Disabled. SSH
must be disabled to configure the protocol parameters.
Note
You cannot disable the SSH server when there is an active SSH
connection.
Host Key ID
Specifies the ID number of the encryption key for the SSH host. The
key must already exist on the switch. To view key ID numbers, refer to
“Displaying the Encryption Keys” on page 372. The default is Not
Defined.