Allied Telesis AT-S63 - Manual (Page 204)

Chapter 17: SNMPv3
204 Section III: SNMPv3
The SNMP tab is shown in Figure 75.
Figure 75. SNMP Tab (Configuration)
4. Click the Enable SNMP Access checkbox to enable or disable SNMP
management. A check in the box indicates that the feature is enabled,
meaning that the switch can be managed from an SNMP management
station. No check indicates that the feature is disabled. The default is
disabled.
Use this parameter to enable the switch to be remotely managed with
an SNMP application program.
Note
If the Enable SNMP Access check box is not checked, the switch
cannot be managed through SNMP. This is the default.
5. If you want the switch to send authentication failure traps, click the
Enable Authentication Failure Traps checkbox. A check in the box
indicates that the switch sends the trap.
6. Click Apply.