Allied Telesis AT-S63 - Manual (Page 168)

Chapter 14: Quality of Service
168 Section II: Advanced Operations
The changes are applied to the flow group.
7. To permanently save your changes, select the Save Config menu
selection.
Deleting a Flow
Group
This procedure explains how to delete a flow group. If the flow group to be
deleted is already part of a QoS policy assigned to one or more switch
ports, you must modify the policy by removing the port assignments before
you can delete the flow group. You can assign the ports back to the policy
after you have deleted the flow group.
To delete a flow group, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Services option.
3. Select the Flow Group tab.
The Flow Group tab is shown in Figure 56 on page 164.
4. Select the flow group to be deleted and click Delete.
The flow group is deleted from the switch.
5. To permanently save your changes, select the Save Config menu
selection.
Displaying the
Flow Groups
To display the flow groups, perform the following procedure:
1. From the Home page, select Monitoring.
2. From the Monitoring menu, select the Services option.
3. Select the Flow Group tab.