Allied Telesis AT-WA7400/EU - Manual (Page 324)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
324
Use the CLI to set the Network Name ( SSID ) for the New Virtual Wireless
Network
AT-WA7400# set interface wlan0vwn1 ssid my-vwn-one
Creating VWN “Two” on Radio One with WPA security
To configure the second virtual wireless network, repeat the previous
procedures as with the following differences:
ˆ Create a second VLAN ID from the web UI with a new SSID
ˆ In the CLI commands, replace wlan0bssvwn1 with wlan0bssvwn2 .
Radio Settings
Note
Before you configure this feature, make sure you are familiar with
the names of the interfaces as described in “Understanding
Interfaces as Presented in the CLI” on page 276. The interface
name you reference in a command determines whether a setting
applies to a wired or wireless interface, the internal or guest
network, or (on a two-radio access point) to radio one or radio two.
Table 25 provides a quick view of Radio Settings commands.
Get IEEE 802.11 Radio Mode
To get the current setting for radio Mode:
AT-WA7400# get radio wlan0 mode
g
Table 25. Radio Settings Commands
Function Command
Get Radio Settings get radio
get radio wlan0
get radio wlan0 detail
Get IEEE 802.11 Radio Mode get radio wlan0 mode
Get Radio Channel get radio wlan0 channel
Get Basic Radio Settings get radio wlan0
Get All Radio Settings get radio wlan0 detail
Get Supported Rate Set get supported-rate
Get Basic Rate Set get basic-rate