Allied Telesis AT-WA7400/EU - Manual (Page 127)

AT-WA7400 Management Software User’s Guide
127
Configuring the IAPP Mapping Table
The Inter-Access-Point Protocol (IAPP) enforces a unique association
through an extended service set (ESS) for the secure exchange of the
station’s security information between access points.
To configure the IAPP map table, perform the following procedure:
1. From the main menu, select Advanced > IAPP Table.
The Configure IAPP map table page is shown in Figure 40.
Figure 40. IAPP Map Table
2. For the Inter-Access-Point-Protocol setting, click Enable.
3. To add a station to the map table:
a. In the fields below the map table, enter the IP and MAC addresses
of the station you want to add.
b. Click Add.
c. Click Update.