Allied Telesis AT-WA7400/EU - Manual (Page 307)

AT-WA7400 Management Software User’s Guide
307
If Key Length is 40 bits and Key Type is “Hex,” then each WEP key
must be 10 characters long.
If Key Length is 104 bits and Key Type is “ASCII,” then each WEP
Key must be 13 characters long.
If Key Length is 104 bits and Key Type is “Hex,” then each WEP Key
must be 26 characters long.
Although the CLI will allow you to enter WEP keys of any number of
characters, you must use the correct number of characters for each
key to ensure a valid security configuration.
AT-WA7400# set interface wlan0 wep-key-1 abcde
AT-WA7400# set interface wlan0 wep-key-2 fghi
AT-WA7400# set interface wlan0 wep-key-3 klmno
AT-WA7400# set interface wlan0 wep-key-4
Set the Authentication Algorithm
The options for the authentication algorithm are Open System, Shared
Key or Both and are shown in Table 13.
In the following example, the authentication algorithm is set to Shared Key:
AT-WA7400# set bss wlan0bssInternal shared-key-authentication on
AT-WA7400# set bss wlan0bssInternal open-system-authentication
off
Get Current Security Settings After Re-Configuring to Static WEP Security
Mode
Now use the get command again to view the updated security
configuration and see the results of the new settings. The following
Table 13. Authentication Algorithm Commands
Function Command
Set Authentication
Algorithm to
Open System
set bss wlan0bssInternal open-system-authentication on
set bss wlan0bssInternal shared-key-authentication off
Set Authentication
Algorithm to
Shared Key
set bss wlan0bssInternal open-system-authentication off
set bss wlan0bssInternal shared-key-authentication on
Set Authentication
Algorithm to
Both
set bss wlan0bssInternal open-system-authentication on
set bss wlan0bssInternal shared-key-authentication on