Allied Telesis AT-WA7400/EU - Manual (Page 297)

AT-WA7400 Management Software User’s Guide
297
Get Client Associations
Get Neighboring Access Points
The Neighboring access point view shows wireless networks within range
of the access point. These commands provides a detailed view of
neighboring access points including identifying information (SSIDs and
MAC addresses) for each, and statistical information such as the channel
each access point is broadcasting on, signal strength, and so forth.
To see the kinds of information about access point neighbors you can
search on, type
get detected-ap TAB TAB.
AT-WA7400# get detected-ap
[Enter] * Get common fields *
band Frequency band
beacon-interval Beacon interval in kus (1.024 ms)
capability IEEE 802.11 capability value
channel Channel
detail * Get all fields *
erp ERP
last-beacon Time of last beacon
mac MAC address
num_beacons Number of beacons received
phy-type PHY mode detected with
privacy WEP or WPA enabled
AT-WA7400# get association
Interf Station Authen Associ Rx-pac Tx-pac Rx-byt Tx-byt Tx-rat
wlan0 00:0c:41:8f:a7:72 Yes Yes 126 29 9222 3055 540
wlan0 00:09:5b:2f:a5:2f Yes Yes 382 97 16620 10065 110
AT-WA7400# get association detail
Inter Station Authe Assoc Rx-pa Tx-pa Rx-byt Tx-byt Tx-ra Liste
wlan0 00:0c:41:8f:a7:72 Yes Yes 126 29 9222 3055 540 1
wlan0 00:09:5b:2f:a5:2f Yes Yes 382 97 16620 10065 110 1