Allied Telesis AT-WA7400/EU - Manual (Page 277)

AT-WA7400 Management Software User’s Guide
277
Table 4. Interfaces in the CLI
Interface Description
lo Local loopback for data meant for the access point itself.
eth0 The wired (Ethernet) interface for the internal network.
br0 The internal bridge represents the internal interface for the access point. To
telnet or ssh into the access point, use the IP address for this interface.
br0 consists of:
• eth0 (or vlan SomeNumber if you have VLANs configured)
• wlan0
• wlan1 (if the access point is a two-radio access point)
The IP address of the access point is provided in the output detail for br0.
So, a useful command is
get interface . This gives you common
information on all interfaces. From the output results, you can find the IP
address for
br0
. Use this IP address to connect to the access point.
brguest The guest bridge, which consists of eth1 and wlan0guest.
brvwn1 The bridge interface for virtual wireless network (VWN) 1.
On a one-radio access point, the bridge interface for VWN1 consists of:
• wlan0vwn1
• vlan VLANID where VLANID is a four-digit VLAN ID that you provided. (For
example, if you provided a VLAN ID of 1234, the VLAN interface would be
vlan1234.
On a two-radio access point, the bridge interface for VWN1 consists of:
• wlan0vwn1
• wlan1vwn1
• vlan VLANID where VLANID is a four-digit VLAN ID that you provided. (For
example, if you provided a VLAN ID of 1234, the VLAN interface would be
vlan1234.