Allied Telesis AT-WA7400/EU - Manual (Page 149)

AT-WA7400 Management Software User’s Guide
149
Transmit Power
Provide a percentage value to set the transmit power for this access
point.
The default is to have the access point transmit using 100 percent of
its power.
ˆ In most situations, Allied Telesis recommends keeping the default
and having the transmit power set to 100 percent. This is more
cost-efficient because it gives the access point a maximum
broadcast range and reduces the number of access points needed.
ˆ To increase capacity of the network, place access points closer
together and reduce the value of the transmit power. This setup
helps reduce overlap and interference among access points. A
lower transmit power setting can also keep your network more
secure because weaker wireless signals are less likely to
propagate outside of the physical location of your network.
Preamble (This setting applies only to radio two)
Rate Sets
Radio one and radio two have different rate sets. See “Configuring the
Rate Sets” on page 150 for information.
3. Click Update to save your settings.