Allied Telesis AT-WA7400/EU - Manual (Page 310)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
310
bss wlan0bssInternal
security static-wep
wpa-personal-key
wep-key-ascii yes
wep-key-length 104
wep-default-key 4
wep-key-1 abcde
wep-key-2 fghij
wep-key-3 klmno
wep-key-4
vlan-interface
vlan-id
radio
remote-mac
wep-key
Set Security to IEEE 802.1x
Set the Security Mode
AT-WA7400# set interface wlan0 security dot1x
Set the Authentication Server
You can use the built-in authentication server on the access point or an
external RADIUS server. Table 14 lists the authentication server
commands.
Note
To use the built in authentication server, set the RADIUS IP address
to that used by the built-in server (127.0.0.1) and turn RADIUS
accounting off because it is not supported by the built-in server.
Table 14. Authentication Server Commands
Function Command
Set the access point to use the
built-in authentication server set bss wlan0bss Internal radius-ip 127.0.0.1