Allied Telesis AT-WA7400/EU - Manual (Page 306)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
306
Note
The Key Length values used by the CLI do not include the
initialization vector in the length. On the web UI, longer Key Length
values may be shown which include the 24-bit initialization vector. A
Key Length of 40 bits (not including initialization vector) is equivalent
to a Key Length of 64 bits (with initialization vector). A Key Length of
104 bits (not including initialization vector) is equivalent to a Key
Length of 128 bits (which includes the initialization vector).
To set the WEP Key Length, type one of the commands in Table 11.
The following example sets the WEP Key Length to 40.
AT-WA7400# set interface wlan0 wep-key-length 40
Set the Key Type
Valid values for Key Type are ASCII or Hex. The following commands set
the Key Type.
In the following example, the key type is set to ASCII:
AT-WA7400# set interface wlan0 wep-key-ascii yes
Set the WEP Keys
Note
The number of characters required for each WEP key depends on
how you set Key Length and Key Type:
If Key Length is 40 bits and the Key Type is “ASCII,” then each WEP
key be 5 characters long.
Table 11. WEP Key Length Commands
Function Command
Set the WEP Key Length to 40 bits set interface wlan0 wep-key-length 40
Set the WEP Key Length to 104
bits set interface wlan0 wep-key-length 128
Table 12. Key Type Commands
Function Command
Set the Key Type to ASCII set interface wlan0 wep-key-ascii yes
Set the Key Type to Hex set interface wlan0 wep-key-ascii no