Allied Telesis AT-WA7400/EU - Manual (Page 112)

Chapter 10: Configuring Security
112
Configuring Security Settings
The following section explains how to configure security modes on the
access point. Keep in mind that each wireless client that wants to
exchange data with the access point must be configured with the same
security mode and encryption key settings consistent with access point
security.
On a two-radio access point, these Security Settings apply to both radios.
Note
Security modes other than plain text apply only to configuration of
the internal network. On the guest network, you can use only plain
text mode. (For more information about guest networks, see
Chapter 11, “Setting Up Guest Access” on page 131.)
Broadcast SSID,
Station Isolation,
and Security
Mode
To configure the broadcast SSID, station isolation, and security Mode,
perform the following procedure:
1. From the main menu, select Advanced > Security.
The Security page is shown in Figure 32.
Figure 32. Security Page