Videotec NXPTZT - Manual (Page 9)

Instruc
tions manual - English - EN
9 MNVCNXPTZT_1343_EN
• The separate protective earthing terminal provided
on this product shall be permanently connected
to earth.
• For continued protection against risk of fire,
replace only with same type and rating of fuse.
Fuses must be replaced only by service personnel.
• The installation is type TNV-1, do not connect it to
SELV circuits.
• In order to reduce the risk of fire, only use UL Listed
or CSA certified telecommunication line cord sizes
greater than or equal to 26AWG.
• Hazardous moving parts. Keep fingers and other
body parts away.
• Connect the device to a power source
corresponding to the indications given on the
marking label. Before proceeding with installation
make sure that the power line is properly isolated.
The supply voltage should never exceed the limit
(+/-10%).
• The device should be mounted so that it is
accessible only to the technician/installer because
the moving parts constitute a residual risk of injury
caused by movement of said parts.
• Attach the Dangerous Moving Parts label near the
device. (Fig. 4, page 12).
• Do not use the appliance in the presence of
inflammable substances.
• Do not allow children or unauthorised people to
use the appliance.
• The appliance should only be considered switched
off when the power supply has been disconnected
and the connecting cables to other devices have
been removed.
• Only skilled personnel should carry out
maintenance on the device. When carrying out
maintenance, the operator is exposed to the risk of
electrocution and other hazards.
• Use only the accessories indicated by the
manufacturer. Any change that is not expressly
approved by the manufacturer will invalidate the
guarantee.
• Connect the coaxial cable to earth.
• Before connecting all the cables make sure the
device is properly connected to the earth circuit.
• If the device has to be removed from the
installation, always disconnect the earth cable last.
• Take all necessary precautions to prevent the
apparatus from being damaged by electrostatic
discharge.
• Handle the unit with great care, high mechanical
stress could damage it.
• Make especially sure that the power supply line is
insulated at a sufficient distance from all the other
cables, including lightning protection devices.